"The one thing I'm looking for is the grey [or tan] plastic cap
for the drivers seat that sits at the joint between the back and
the seat that holds the seatbelt and hides the joint and spring."
1984-87 COVER, passenger seat back reclining hinge, lower
20596788 $8.51
1984-87 COVER, driver seat bac reclining hinge, lower
20596789 $8.51
You have to paint these to match, so you might want to look in a junk yard.
From: Scott Backer
- First get 13mm box end wrench (if I remember right). Also a 1/4" drive
ratchet is perfect for this job...using a 13mm socket.
- unhook the connector for the speakers at the base of the seat.
[84-85 models only]
- Slide the seat all the way back remove the two nuts from the front
- Slide the seat to the front and remove the two rear nuts...
- with the seat all the way reclined forward you are ready to remove it. Get
a heavy tarp/blanket and lay over
the interior trim and rocker panel. Open the door as far as possible, roll
down the window.
- Now gently lift the seat out and start by swinging the top half out then
the bottom of the seat. Careful not to scracth anything, like the dash, with
the runners.
Installation is the reverse, you might have to push and shove the seat back
onto the studs, but it will fit.
From: Jason Wenglikowski
[Top] |
Online Service Guide Main Page